Bog oak guitar back and sides set WAA**

Bog oak guitar back and sides set western size grade AAA**

Quercus spp from East Anglia

910kg/m3

Photo is of a typical set.

Inky black to very dark brown and with a significantly higher density and hardness than ordinary oak, bog oak was created when prehistoric forests were submerged under water and silt in anaerobic conditions thousands of years ago.

Fiendishly hard to get through the drying process but reliable and stable when done. A handsome dark and dense timber for guitar building producing good quality instruments.

When carbon dated, bog oak from this source was found to be 5300 years old.

AAA – Quarter sawn wood or nearly so.

AA – Wood that is quartered to one edge, (where the centre joint of the back will be ), gradually straying from the quarter ending up slab sawn at the opposite edge.

A – Wood that is slab sawn, the main slab sawn area being approximately half way across the board.

* - One or more asterisks may be added to the grade mark to indicate wood that is aesthetically more pleasing or desirable by virtue of colour, intensity of figure or fineness of grain.

Back and sides sets are pre matched for colour and character.

Back and sides sets frequently are different grades for the back and the sides e.g. AAA sides and AA back. The valuation of these sets assumes the back and the sides each represent 50% of the value of a set and are then added together.

Western size backs 2pc 560mm x 205mm and up x 4mm
sides 2pc 830mm x 120mm and up x 3.5mm

Classic size backs 2pc 530mm x 190mm and up x 4mm
sides 2pc 780mm x 100mm and up x 3.5mm